Find a professional gyprocker contractor in NSW

Patch up 4 x holes in Gyprock and make ready for painting (Painting not required). 3 on the ceiling and 1 on a wall.

Need holes fixed in wall 3 in total one i tried to fix that may need to be redone

Need to fix gyprock around 86cmx65cm on ceiling

Replace section of gyprock in living room. And also patch hole. Easy access. Must plaster but sanding not necessary. See photo. Must supply all materials.

1. Remove water damaged gyprock from garage ceiling over an area of 1500mm by 1800mm to 2000mm by 2000mm. Prior to removal of damaged gyprock all cables in the ceiling space above are to be located and protected 2. Dispose of damaged gyprock off site. 3. Supply and fix new gyprock including taping and setting joins. Corner to be square set. 5. Sand back joins ready for painting 6. Clean up Please note original leak in roof has been repaired and sarking patched up.

I need a budget but good price to gyprock a 6x3 outside room.The furring chanels and steel stud walls are done.I just need to install the insulation and timber door trim and trim around windows before gyprocking,I need the ceiling square set as well as the center beam with no cornice and the gyprock around the windows and door will finsh next to the timber trim .Need it sanded and ready to paint The ceiling height at the highest point is 2.6 mtrs and lowest point 2.3 mtrs it has 1 sliding door and 2 windows. Easy access to the room looking at having the Job ready to go in about 2 weeks.

Need to put up a mirror on a wall. Mirror is quite heavy.

Gyprocker needed for a small job, Some damages occurred during the move and need them fixed. Photos of damages attached below. Please provide a quote to fix the damages

1. Gyprock part of 2 walls (marked in red in photos attached) and sanding to prepare for painting 2. Sand ceiling and cornice where wall has been removed. Gyprock has been applied just needs to be sanded and refined ready to be painted. Will provide the following: - Gyprock topping compound - Professional sander - Spatulas/tools to apply Gyprock

Need to patch up the Gyprock in the roof as per image and paint to tidy up.

Please see photos, roof collapsed not sure why

Fix 8 Floating shelves to wall. All very small approx 40cm wide. Must be level. All fixings included in pack. Mountings already in place on back of shelves so should be easy install. Previous experience hanging similar shelves desired

Nib L shape wall needs to be set and sanded. Top can be rough as timber is going on top but corners need to be touched up and base coated + top coat and sand. Angles are on but 1 90mm x 2.7m corner needs a strip on it with an angle. Joint master and half a bag of base coat is on site and angle same as stud adhesive. And gyprock is on site.

General repair of Gyprock wall

We have a hole in the ceiling due to water leak. The water leak is now fixed so need to close the ceiling with patchwork and repaint. Or even install an access panel for future use. It is a 600x300 hole in the ceiling. Images attached for reference.

A hole was cut for an AC vent by mistake, the new hole cutout was used to fill it up and screwed in, but its not a proper job. Need it fixed, should not take long.

We have some holes in our ceiling after some electrical work has been done. These need to be fixed and ready for us to paint. We also have a sliding door which has come off the tracks that needs to be put back into place.

We need to remove the centre gyprock wall we put in to cover an existing wall with a window. We now need this wall removed neatly and cleanly as it is a rental. There are wooden studs too. The gyprock will also need to be taken off site once the removal is done. Only one wall needs to be removed approx 4 meter long 3 meter high

I need a wall gyprock wall set and sanded and a cornice installed. Materials not supplied. Wall 800mm wide and 2500 high. Need both sides done.

Patch up hole gyprock in ceiling. Around 700mm x 700mm. Ground floor.